gre.move control

gre.move_control(
    control_name,
    dx,
    dy,
    x,
    y,
    [ah],
    [av]
)
            

Move a controls to a new position.  The control_name is the name of the control or a variable.  Setting dx and or dy will move the layer by the specified delta from its current position.  The  dx and dy values can be 0 to set an absolute position using the x and y values only.

Optional anchors allow for automatic adjustment of x and y values:

Horizontal:

  • grd.LEFT anchor will not adjust the input. This is the default behavior.

  • grd.CENTER anchor will adjust the x input by half the control width.

  • grd.RIGHT anchor will adjust the x input by the full control width.

Vertical:

  • grd.TOP anchor will not adjust the input. This is the default behavior.

  • grd.CENTER anchor will adjust the y input by half the control height.

  • grd.BOTTOM anchor will adjust the y input by the full control height.

Parameters: control_name The model full path of the control to move dx A delta from the current x position or 0 to move using x dy A delta from the current y position or 0 to move using y x The x position to move to in absolute co-ordinates (omit to use dx) y The y position to move to in absolute co-ordinates (omit to use dy) ah The horizontal anchor, gre.LEFT, gre.CENTER or gre.RIGHT (Optional, default is gre.LEFT) vh The vertical anchor,gre.TOP, gre.CENTER or gre.BOTTOM (Optional, default is gre.TOP)

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.